感應門安裝后，應定期進行維護和檢查，以確保正常運行。即使使用高性能的感應門，如果不能達到計劃的功能和性能，在日常使用中也會出現很多故障，一次開啟故障就會影響整個建筑的效果。因此，必須定期檢查感應門的設備，以確保其運行順暢，從而保持其使用壽命。

After the induction door is installed, it shall be maintained and inspected regularly to ensure normal operation. Even if the high-performance induction door is used, if it cannot achieve the planned function and performance, there will be many faults in daily use. One opening fault will affect the effect of the whole building. Therefore, the equipment of the induction door must be checked regularly to ensure its smooth operation and maintain its service life.

比如導軌中可能有異物，會在運行時產生滑動噪音，加速滑動件的磨損。這樣可以檢查排除異物，切斷故障等。這些問題可以通過定期檢查來。例如，皮帶與驅動和從動之間可能會因干燥而發生摩擦，產生噪音，皮帶容易斷裂。此時，皮帶上的黃油就可以了。將旋轉門的故障控制在小范圍內。

For example, there may be foreign matters in the guide rail, which will produce sliding noise during operation and accelerate the wear of sliding parts. This can check and eliminate foreign matters, cut off faults, etc. These problems can be solved through regular inspection. For example, friction may occur between the belt and the drive and driven due to drying, resulting in noise, and the belt is easy to break. At this point, the butter on the belt is OK. Control the fault of revolving door in a small range.

感應門的驅動裝置由電機和減速器或電機和液壓系統組成。它根據控制裝置的指令和驅動裝置設定的程序，驅動門的開啟和關閉。從驅動裝置到門體的運動中間應該有傳動機構，減速機是傳動機構的一部分。

The driving device of induction door is composed of motor and reducer or motor and hydraulic system. It drives the opening and closing of the door according to the command of the control device and the program set by the driving device. There should be a transmission mechanism in the middle of the movement from the driving device to the door body, and the reducer is a part of the transmission mechanism.

此外感應門的控制系統基本相同，可以根據門的控制系統進行連接，如開門信號、門禁系統、裝置、集中控制等。但也可以組合由各類人員根據建筑物的使用特點，合理配置輔助設備的控制系統。

The control system of the external sensing door is basically the same, which can be connected according to the control system of the door, such as door opening signal, access control system, safety device, centralized control, etc. However, the control system of auxiliary equipment can also be reasonably configured by various personnel according to the use characteristics of the building.

開門信號，自動開門系統是觸發信號的來源。常見的有微波雷達和紅外傳感系統。步行感應門的主要特點是，如果配件內有人但禁止移動，則雷達或紅外設備不會反射，從而達到的效果。并且對開門機也有保護作用。

Door opening signal, automatic door opening system is the source of trigger signal. Common are microwave radar and infrared sensing system. The main feature of walking induction door is that if there are people in the accessories but it is forbidden to move, the radar or infrared equipment will not reflect, so as to achieve the effect of energy saving. It also has a protective effect on the door opener.

根據安裝環境和要求，濟南感應門應考慮感應門的配置：傳感器的選擇：在酒店、寫字樓中，可以選擇高靈敏度的傳感器；在銀行、商店等人行道上經常有人經過的地方，選擇狹窄區域的微波感應器（電流感應器可以調節）。

According to the installation environment and requirements, the configuration of the sensing door in Jinan should be considered: the selection of sensors: in hotels and office buildings, high-sensitivity sensors can be selected; In places where people often pass on banks, shops and other sidewalks, select microwave sensors in narrow areas (current sensors can be adjusted).

輔助裝置：如在賓館等場所需要，為避免因感應故障而發生夾人事故，可選擇加裝防夾紅外傳感器。配備備用電源：為保證感應門在斷電時能正常工作，可配備備用電源。

Safety auxiliary device: if required in hotels and other places, anti pinch infrared sensor can be installed to avoid pinch accident due to induction failure. Equipped with standby power supply: in order to ensure that the induction door can work normally in case of power failure, it can be equipped with standby power supply.

根據位置的不同，一些感應門傳感器每天運行數千次，這使得所有設備必須始終高速運行。為了為不同的客戶群體提供相應的個性化產品和方案，本企業已成為突出的優勢。詳細的相關內容您就來關注網站m.mlzqjgx.cn看看怎么回事吧。

Depending on the location, some sensing door sensors run thousands of times a day, which makes all equipment must always run at high speed. In order to provide corresponding personalized products and solutions for different customer groups, the enterprise has become a prominent advantage. For details, please follow the website m.mlzqjgx.cn See what's going on. Www. 68mn.